Loading ...
Loading ...
Loading ...
14
STEP 7 INSTALL LOWER CABLE
LOWER CABLE (76)
Ball End Steel Ball End
L1
L4
L2
L3
L5
L6
84
104
52
Fig. L1
A3
52
104
84
14
Fig. L3
104
84
1
52
Fig. L2
Fig. L6
84
1
104
52
Fig. L4
9
83
65
65
52
100
100
104
Fig. L5
1. See Fig. L1 Route the steel ball end of the LOWER CABLE (76) under Pulley L1 mounted at the front of the
Low Pull Station using one 3/8" X 1-3/4" HEX HEAD BOLT (84) and one 3/8" NYLA-NUT (104).
2. See Fig. L2 Continue back to Pulley L2 mounted on the BASE FRAME (1) using one 3/8" X 1-3/4" HEX HEAD
BOLT (84) and one 3/8" NYLA-NUT (104).
3. See Fig. L3 Route the cable underneath Pulley L2 and then up to Pulley L3 mounted in bottom of the DOUBLE
PULLEY BOLCK (14) using one 3/8" X 1-3/4" HEX HEAD BOLT (84) and one 3/8" NYLA-NUT (104).
3. See Fig. L4 Continue down to Pulley L4 mounted to the BASE FRAME (1) using one 3/8" X 1-3/4" HEX HEAD
BOLT (84) and one 3/8" NYLA-NUT (104).
4. See Fig. L5 Route the cable underneath Pulley L4 and Pulley L5 mounted in the slot in the bottom of the
FRONT UPRIGHT (3) using one 3/8" X 2-3/4" HEX HEAD BOLT (83), two 3/8" WASHERS (100), two 3/8" ID
FLANGE BUSHINGS (65), and one 3/8" NYLA-NUT (104).
5. See Fig. L6 Connect the steel ball end of the cable to the receptor bracket L6 welded to the LEG EXTENSION
ARM (9).
Loading ...
Loading ...
Loading ...