Loading ...
Loading ...
Loading ...
8
7. Locate the Tone
Arm Counterweight
and the supplied
small bottle of
Bearing Oil. Using
a small cotton swap
(Q-Tip) apply one
drop of the oil to
the inside center of
the Counterweight
“O” Rings. Refer to
figure 8.
9. Remove the protective film material from the
Tone Arm Rest Position. Refer to figures 12
and 13.
Note: If another Phono Cartridge (such as the
McIntosh MCC10) is to be used with the
MT2 turntable, proceed to “Installing a non-
supplied Cartridge” at this time on page 10.
8. Align the inside opening of the Counterweight
with the rear end of the Tone Arm. Then slowly
rotate the Counterweight until the front vertical
surface of it lines up with the center of the Blue
Point. The center of Blue Point Position Marking
on the surface of the Tone Arm is for the supplied
No. 2 Cartridge. Refer to figures 9, 10 and 11.
Note: It is recommended to check the tracking
force pressure using the supplied Sty-
lus Tracking Force Gauge as outlined on
page 12.
Figure 9
Blue Point No. 2
Position Marking
Center of the Blue
Point No. 2 Position
Assembling the Turntable, con’t
Figure 6
Bottom Foot
Figure 7
Turn to adjust height
Figure 10
Figu re 11
Center of Position
Marking
Figure 12
Protective
Film
Figure 8
Coat the inside “O”
Rings with a drop of Oil
Loading ...
Loading ...
Loading ...