Loading ...
Loading ...
Loading ...
9
spoon supplied and level it o evenly (g. 11). As a gener-
al rule, use a level measure of coee (approx 7 grams) for
every cup of coee required (for example, 10 measures to
obtain 10 cups).
• Close the lter-holder door and place the carafe, with cover
in place, onto the warming plate.
• Press the ON/OFF button. The light on the button indicates
that the drip coee-maker is in operation.
• The coee will begin to dispense after a short time.
It is perfectly normal for the appliance to emit steam while the
coee is percolating.
To keep the coee hot after the percolation process has nished,
place the carafe on the hot plate and leave the machine turned
on (with the drip coee light on): the coee in the carafe will be
kept at the right temperature.
• To turn o the machine press the ON/OFF switch.
8. ESPRESSO COFFEE
The rst time you use the appliance, wash all accessories and
rinse the internal circuits by proceeding as though you were
making coee until you have used at least two tanks of water.
You can then proceed to make coee.
8.1 Preheating the coee unit
To make espresso coee at the right temperature, the coee
maker should be preheated as follows:
1. Press the ON/OFF switch (g. 12) to turn the appliance on.
The power light (B3) comes on.
2. Insert the lter to the lter holder (g. 13). Make sure the
projection is correctly inserted in the slot. Attach the lter
holder with lter to the appliance (g. 14) without adding
pre-ground coee. Use the smaller lter to make one cof-
fee or the larger lter to make two coees.
2. Place a cup under the lter holder. Use the same cup as will
be used to prepare the coee in order to preheat it.
3. Wait until the light comes on and immediately af-
terwards press the button (g. 15). Continue deliver-
ing water until the light goes o, then interrupt delivery by
pressing the same button and empty the cup.
(It is normal for a small and harmless pu of steam to be given
o when removing the lter holder).
8.2 How to make espresso coee using pre-
ground coee
1. After preheating the appliance and lter holder as de-
scribed in the previous paragraph, use the smaller lter to
make one coee or the larger lter to make two coees.
2. To make just one coee, place one level measure of pre-
ground coee (about 7 g) in the lter (g. 16). To prepare
two coees, place two loosely lled measures (about 6+6
g) of pre-ground coee in the lter. Fill the lter a little at a
time to prevent the pre-ground coee from overowing.
Important:
For correct operation, before lling with pre-ground coee,
make sure there are no coee residues left in the lter from the
last time you made coee.
3. Distribute the pre-ground coee evenly and press lightly
with the presser (g. 17).
Correct pressing of the pre-ground coee is essential to ob-
tain a good espresso. If pressing is excessive, coee delivery
will be slow and the froth will be dark. If pressing is too
light, coee delivery will be too rapid and the froth will be
skimpy and light coloured.
4. Remove any excess coee from the rim of the lter holder
and attach to the appliance. Turn as far as it will go (g. 14)
to avoid water leaking out.
5. Place the cup or cups under the lter holder spouts (g.
18). You are recommended to warm the cups before mak-
ing coee by rinsing them with a little hot water.
6. Make sure the light is on (if o, wait until it comes
on), then press the button (g. 15). When the de-
sired amount of coee has been delivered, press the same
button to interrupt the ow.
7. To remove the lter holder, turn the handle from right to
left.
Danger of burns!
To avoid splashes, never remove the lter holder while the ap-
pliance is delivering coee.
8. To dispose of the used coee, block the lter in place us-
ing the lever incorporated in the handle, then empty the
grounds by turning the lter holder upside down and tap-
ping it rmly (g. 19).
9. To turn the appliance o, press the ON/OFF button on the
left side of the machine.
How to prepare espresso coee using pods
1. Preheat the appliance as described in the section “PRE-
HEATING THE COFFEE UNIT”, making sure the lter holder
is attached. This obtains a hotter coee.
Please note:
Use pods conforming to the ESE standard, indicated on the pack
by the following symbol.
The ESE standard is a system accepted by leading
pod producers and enables espresso coee to be
prepared simply and cleanly.
2. Place the small lter in the lter holder, making sure the
Loading ...
Loading ...
Loading ...