Loading ...
Loading ...
8
rinse it under a running tap (g. 2).
• Open the lter support and carefully put the lter in place
as shown in g. 2.
• Close the lter container carefully (g. 2), and reposition it
in its slot, pushing it rmly downwards.
•
The Antichlorine lter should be replaced after 80 cycles, and
at least after every 6 months of operation.
6. FIRST USE
When using the appliance for the rst time, all the accessories
and the internal circuits must be washed as follows:
• DRIP COFFEE MAKER: Make at least two carafes of coee
without using ground coee.
• ESPRESSO MAKER: Make at least four cappuccinos without
using ground coee and using water instead of milk.
7. PREPARATION OF DRIP COFFEE
7.1 Setting the clock
When the coee machine is connected to the outlet for the rst
time, “AM 0:00” will ash on the display.
To set the time, proceed as follows:
1. Press the “hour” button (Fig. 3) for about 2 seconds until
the number of hours on the display begins to increase.
2. Before the display stops ashing (about 5 seconds), set the
hour by pressing the “hour” button repeatedly.
3. Set the minutes by pressing the “min” button (Fig. 3) re-
peatedly. (To speed up the operation, hold the button
down.)
4. After setting the time, wait 5 seconds. When the display
stops ashing, the time set is stored.
To reset the time, press the HOUR button for about 2 sec-
onds, and then follow the procedure as described starting
from point 2.
Please note: In the event of a temporary power failure, the
time set does not remain stored in the memory.
7.2 Programming the automatic start (AUTO
BUTTON)
The appliance can be programmed to make drip coee automat-
ically. First, make sure that the time is set correctly.
To set the delayed start (i.e. the time you want the coee to be
made), proceed as follows:
1. Press the AUTO button (Fig. 4) for about 2 seconds until
0:00 ashes on the display.
2. Before the display stops ashing (about 5 seconds), set the
desired hour by pressing the “hour” button repeatedly.
3. Set the minutes by pressing the “min” button repeatedly.
4. After 5 seconds, the display will stop ashing and the pro-
grammed time will be stored.
5. After you have programmed the machine as described
above, just press the AUTO button to have coee made at
the time set (the AUTO indicator light will illuminate).
Please note:
• If you want to change the start time after it has been set,
press the AUTO button for about 2 seconds and then set a
new time as described starting from point 2.
• Keep in mind that at the time set, the appliance will start
to make drip coee only. The espresso maker does not
come on.
7.3 Length of warming time (Automatic shut-
o time)
The appliance is factory-set to keep the coee warm for two
hours after startup.
However, this setting can be changed as follows:
1. Press the ON/OFF button (Fig. 5) for about 2 seconds until
0:00 ashes on the display.
2. Modify the time by repeatedly pressing the HOUR button
(and also the MIN button if required).
3. After setting the time, wait 5 seconds. When the display
stops ashing, the time will be stored.
Please note: If 0:00 is set, the appliance switches o. (You can
set a time within 1 minute and 11hours and 59 minutes).
7.4 “1-4” cups button
You can enhance the avor of your coee by pressing the “1-
4” button after the “ON/OFF” button. This feature activates a
unique brewing process, slowly releasing water into the lter
basket; saturating coee grounds a little at a time extracting
the best avor and aroma from your coee.
To activate, press the “1-4” button (g. 6); the light on the but-
ton will illuminate.
Press the button again to turn the selection o.
Do not use this button if brewing an entire carafe of coee.
You can select this function even when using the auto function.
7.5 Making drip coee
• Open the lter-holder door, rotating it towards the right
(g. 7).
• Fill the carafe to the level indicator relative to number
of cups of coee you wish to prepare, taking care not to
exceed the MAX level (g. 8), otherwise, in order to not
overll the machine, the excess water will spill out from
the back of the unit.
• Then
pour the water into the water-ll compartment of the
appliance (g. 9).
• Position the gold tone lter into the lter-holder (g. 10).
• Put the ground coee in the lter using the measuring
Loading ...
Loading ...
Loading ...