Loading ...
Loading ...
Loading ...
(253,1)
北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
the lever. The headlight flasher works even
though the lighting switch is in the off
position.
When the headlights are on high beam, the
high beam indicator light “
” on the
combination meter also illuminates.
& High Beam Assist Function
s03ah07
NOTE
. The high beam assist function uti-
lizes the stereo camera installed at the
position of the front map lights.
. For details on how to handle the
stereo camera, refer to the Owner’s
Manual supplement for the EyeSight
system.
The high beam assist function automati-
cally changes the headlight from high
beam to low beam (or vice versa).
When all of the following conditions are
met, the headlight will change to high
beam.
. When the vehicle speed increases to or
above 20 mph (32 km/h).
. There is no preceding or oncoming
vehicle.
. The forward area of the vehicle is dark.
. The road does not have a sharp curve.
When any of the following conditions are
met, the headlight will change to low beam.
. When the vehicle speed decreases to
or below 10 mph (16 km/h).
. When the forward area of the vehicle is
bright.
. When there is a preceding or oncoming
vehicle.
. When the EyeSight system is malfunc-
tioning or is temporarily stopped.
NOTE
. Do not overestimate the capacity of
the high beam assist function. The
driver always has the responsibility to
understand the surrounding situation,
to drive safely, and to change the
headlight mode manually if necessary.
. The factory setting (default setting)
for this function is set as “operational”.
This setting can be changed to OFF
(non-operation) at SUBARU dealers.
For more details, contact a SUBARU
dealer.
! How to use the high beam assist
function
s03ah0701
The high beam assist function will be
activated when all the following conditions
are met.
. The light control switch is in the “AUTO”
position and the low beam headlights are
on automatically.
. The turn signal lever is pushed forward.
High beam assist indicator
When the high beam assist function is
activated, the high beam assist indicator
on the combination meter will illuminate.
NOTE
If the high beam assist function is
malfunctioning or is temporarily
stopped, the headlight will be fixed at
low beam.
! Temporary stop of high beam assist
function
s03ah0706
If the high beam assist function stops
temporarily due to poor visibility or abnor-
mal temperature, the message appears on
the combination meter. Once the condi-
tions have been remedied, drive the
– CONTINUED –
Light Control Switch
251
3
Instruments and Controls
Loading ...
Loading ...
Loading ...