Loading ...
Loading ...
Loading ...
Coin Operation
In coin operated machines prices for programs and other operational parameters must be
programmed during machine setup.
Prices can be programmed as dollars and cents or as the number of coins or tokens required to
start and to add additional drying time.
There are four drying programs High, Medium, Low, and No Heat. These four programs can be
programmed for different prices and times. When the machine is in standby mode (i.e. before the
drying program begins), the selected drying program may be changed. Once a drying program has
started, the program may be changed only if all the programs High, Medium, Low and No Heat
have identical settings for price, drying time, and time added for each additional coin or press.
After the initial drying time has been purchased for a selected program, additional drying time may
be added by inserting more coins. The amount of extra time per coin inserted for the selected
program can be programmed in the service registers. Additional drying time up to the maximum
allowed may be purchased.
Price Programming & Drying Time Program Setup
Amount to Start (ATS) service registers 040-043 dene the price that must be paid before a
selected program may be started.
The ATS price is displayed when the machine is idle. As each coin is deposited the display will
count down by the “Coin 1 Value” or “Coin 2 Value” as the coin pulses are received. The following
instructions show how to set up prices for drying programs
1. To enter programming mode, unlock and remove the coin box.
2. Press and release the Service Switch located in the rear of the coin vault to enter service mode.
The display will light up all the LED’s in the display.
3. Press the Start button and the display will show “SE” conrming access to the service registers.
4. Use the “Low” and “No Heat” buttons to navigate to the desired register.
5. Go to register 40, High heat and press Start to enter. The current price will be shown in the
display, blinking.
6. Use the three program selection buttons; Medium, Low, and No Heat to change each of the
three digits in the price display. Each button increments a corresponding digit, left to right, in the
price. Each digit rolls over from 9 to 0 without affecting the other digits. Once the desired price
has been set in the register, press the Start button to save the value and exit the register.
7. If registers 041, 042, and 043 = “0.00” the values of these registers will be set to the same value
as register “040”. If different pricing is desired, program each register separately repeating steps
4-5.
8. Press the Service Switch in the vault to exit service mode.
9. Check the newly entered prices by selecting each program.
Register 030 (Coin / Token Mode) determines how prices are displayed by the machine. When set
to “00” (default), prices are set and displayed with a decimal (e.g. “3.00”). When set to “01”, the
2:1
Coin Meter
Loading ...
Loading ...
Loading ...