Loading ...
Loading ...
Loading ...
28
DRIFTS TO THE LEFT
FIGURE B
DRIFTS TO THE RIGHT
FIGURE A
Ensure the running belt is centered on your treadmill at all times.
Running style and Non-level surface may cause the belt to drift
off center.
Minor adjustments to the two bolts at the rear of the treadmill are
necessary when the belt has drifted off center. See fig. A & B.
1 . Press the Master Power Switch (located at the front of the treadmill)
to the ON position and ensure Safety Key is properly placed onto
the computer console. Press the START button to begin running,
then increase the treadmill's speed to 2 mph.
2 . Stand behind the treadmill to determine which side the belt
is drifting to.
3 . If the belt drifts to the right, turn the right adjustment bolt
90 degree clockwise and the left adjustment bolt
90 degree counterclockwise (See Fig. A).
4 . If the belt drifts to the left, turn the left adjustment bolt
90 degree clockwise and turn the right adjustment bolt
1. Turn the MASTER POWER SWITCH to the ON position and make sure the safety key is pressed in.
2.
Press START button to start running the belt, then increase speed to 2 MPH.
3. Turn both adjustment screws an equal amount, approximately one-quarter turn clockwise.
4. Slow the belt by holding onto the handrails and applying more weight as you walk, (as if you are
walking downhill). Then, stepping heavily on the belt to see if the belt slips.
5. If the belt slips, adjust one-quarter turn clockwise and repeat STEP 4 if necessary.
ALWAYS BE CAREFUL NOT TO OVERTIGHTEN THE RUNNING BELT.
Aligning the Running Belt
turn counterclockwise (See Fig. B).
5 . Observe the tracking of the belt for about two minutes. Repeat Steps 3, 4, and 5 as needed.
Adjusting the Running Belt Tension
Adjust the belt tension if it begins to slip on the rollers. This is important to increase the longevity of the
treadmill’s components.
Before adjusting the belt tension, keep the belt loose.
Cleaning & Inspecting the Running Belt
Turn off power and unplug from electrical outlet.
Carefully position the treadmill on its side.
Use a damp cloth to wipe off the inside of the running belt. Carefully rotate the running belt by hand
to clean the entire inside face. Return treadmill to its upright position.
If running belt edges are frayed, check the running belt adjustment.
If seams are splitting, call your retailer or nearest authorized service center.
Loading ...
Loading ...