Loading ...
Loading ...
Loading ...
21
20
19
LASER
ON
OFF
SETTING CUTTING DEPTH (FIG. 19)
The depth of cut can be preset for even and repetitive
shallow cuts.
● Adjust the cutting head down until the teeth of the
blade are at the desired depth.
●
While holding the upper arm in that position, turn
the stop knob (1) until it touches the stop plate (2).
● Recheck the blade depth by moving the cutting
head front to back through the full motion of a
typical cut along the control arm.
MAXIMUM CUTTING DEPTH (FIG. 19)
The maximum depth travel of the cutting head was
set at the factory. Check to see that the blade does
not extend more than 1/4 in. below the table insert,
and does not touch the control arm throat or any part
of the base or table. If the maximum depth needs
readjusting:
● Loosen the bolts of the stop plate (2).
● Move the cutting head down until the blade
extends just 1/4 in. below the table insert.
● Adjust the stop place to touch the bottom of the
stop knob (1) when the stop knob is raised fully.
● Recheck the blade depth by moving the cutting
head front to back through the full motion of a cut
along the control arm. If the blade touches the
inside of the control arm, readjust the setting.
THE LASER GUIDE (FIG. 20, 21)
For your own safety, never connect the plug to a
power source outlet until all the adjustment steps
are complete and you have read and understood
the safety and operational instructions.
Your tool is equipped with a laser guide using a Class
IIIa laser beam. The laser beam will enable you to
preview the saw blade path on the workpiece to be
cut before starting the miter saw. This laser guide is
powered by two AAA 1.5 volt batteries.
● To turn laser on, press on/off rocker switch (1)
to “ON” position.
●
To turn laser off, press on/off rocker switch to
“OFF” position.
2
1
1
WARNING
Loading ...
Loading ...
Loading ...