Loading ...
Loading ...
Loading ...
© 2017 DJI All Rights Reserved.
9
Ensure that there are no open circuits or short circuits when
soldering the ESC cables.
It is recommended that you solder a power connector on the
PDB for the battery.
Connection
Tools Required: Power distribution board (PDB)*, electric soldering iron
and soldering tin
1. Solder the ESC’s black and gray power cables to the pads on the
PDB.
* Use a PDB which has sufcient trace spacing and current capacity, according
to the number of ESCs and the battery voltage.
2. Connect the signal cable to your ight controller. The signal cable’s
white wire transmits the control signal; the gray wire transmits the
data signal; the black wire is for ground.
3. Connect the motor to the ESC.
Signal Cable (To ight controller)
Power Cables (Gray for
Positive, Black for Negative)
Motor Cables
Loading ...
Loading ...
Loading ...