Loading ...
Loading ...
Loading ...
3-12
Lift out filter (K) and hand wash in cold
water with a mild detergent.
Let filter air dry then reposition. Replace
lens and screws.
Should you want to replace this filter, ask
for HOOVER part no. 38765024 (filter pack
-
age part no. 40110004).
Do not operate cleaner without any of the fil
-
ters in place.
3-11
Cleaning final filter
The final filter assists in returning clean air
to the room.
Using a screwdriver, remove the two
screws as shown and lift off lens.
I
J
3-6
Grasp end of cartridge filter and gently
pull it away from pre-filter. Remove car
-
tridge from assembly.
The pre-filter can be cleaned with a brush
and then rinsed with water. Allow pre-filter
to dry thoroughly.
3-7
It is recommended that the HEPA car-
tridge filter be cleaned by tapping either of
the ends until no more dust particles fall
from the filter. DO NOT tap the soft, pleated
sides of the filter. It could damage the filter.
Do not rinse or wash the filter.
3-8
To re-assemble the filter assembly, place
large knob of cartridge filter in hole on
bottom of pre-filter.
Snap top of cartridge filter into place.
3-9
Align grooves (I) on pre-filter frame with
ribs (J) in dirt cup.
3-10
Slide filter assemby down into cup until a
light snap is felt. Gently pull up on assem
-
bly to ensure that it is seated properly in
the cup. Ensure that no part of pre-filter
screen extends above top edge of dirt
cup.
Replace lid and return cup to cleaner (Fig.
3-4).
RIGHT
WRONG
K
Remove lens - Disconnect cleaner from
electrical outlet.
Using a screwdriver, remove the two
screws as shown and lift off lens.
3-14
3-13
What to buy
This cleaner uses a 12 volt, wedge base type
912 bulb, HOOVER part No.
27313107.
Install bulb - Pull old bulb straight out
of socket. Push new bulb straight into
socket until locked in place. Do not twist
bulb.
Excessive force is not required.
Headlight replacement*
*Available on select models only.
8
Loading ...
Loading ...
Loading ...