Loading ...
Loading ...
Loading ...
2-12
F
G
H
Select proper tool
F. Dusting brush may be used for carved
furniture, table tops, books, lamps,
lighting fixtures, venetian blinds,
baseboards, shutters, and registers.
G. Furniture nozzle may be used for
upholstered furniture, draperies,
mattresses, clothing, automobile interiors,
and carpeted stairs.
H. Crevice wand (stores inside extension
wand) can be used in tight spaces,
corners and along edges in such places
as dresser drawers, upholstered furniture,
stairs and baseboards. It can also be
used for extra reach with the dusting
brush and/or extension wand.
I. Extension wand is used to give extra
length to your hose. Use it with any of the
above tools.
Cleaning tools
Tools allow for cleaning surfaces above
the floor and for reaching hard to clean
areas.
• The cleaner is ready for tool use when
handle is in upright position.
• For best tool performance, set the ON-
OFF-HUSH™ switch to ON and set the
Power Boost Switch to lock.
CAUTION: Agitator continues to rotate while
cleaner handle is in upright position. Avoid
tipping cleaner or setting it on furniture,
fringed area rugs or carpeted stairs during
tool use.
I
2-11
Stair cleaning
A stair cleaning handle has been designed
for ease in using your cleaner on stairs.
With handle in operating position, place
fingers under edge of stair cleaning handle
and guide cleaner with other hand on
upper handle.
As an alternative, you may use the hose
and furniture nozzle for stair cleaning.
Clean from bottom to top.
When using cleaning tools, the agitator will
continue to rotate.
CAUTION: To avoid personal injury or
unnecessary wear to carpet, and to prevent
the cleaner from falling, always place it at
the bottom of the stairs.
Settings
For maximum cleaning performance,
the following carpet height settings are
recommended.
• Low setting: for all types of carpet and hard
floors.
Note: If the cleaner is difficult to push, rotate
knob to the next higher setting.
• Medium and High settings: for deeper pile
carpet where easier pushing effort is desired,
while maintaining good cleaning
performance.
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front of
cleaner) as shown and will prevent rug
from clinging to cleaner. Continue to lift up
nozzle so that when you have reached the
edge, it is completely off the rug. Move
cleaner back to start again, lower nozzle,
and use only forward strokes.
Carpet height
adjustment
The cleaning of carpet and rugs takes place
at the nozzle (D).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, turn
the carpet height adjustment knob (E) to the
desired setting.
For ease in turning the knob, place handle in
upright position.
Nozzle wonʼt move to adjusted position until
handle is lowered to operating
position.
2-8
D
E
2-10
2-9
Continued ➜
5
Loading ...
Loading ...
Loading ...