Tap to switch temp unit to °C/°F on LCD screen. Press and hold for 3 seconds to clear MAX and MIN records for temp and humidity.
Maximum/Minimum temp and humidity readings in the past.
DRY Humidity is below 30%.
COMFORT Humidity is between 30% - 60%, while temp is 20°C - 26°C.
WET. Humidity is above 60%.
Elsewise. No icon.
Display. Bluetooth is connected
Not shown Bluetooth isn’ t connected.
Accuracy Humidity: +-3% / Temp: +-0.3°C
Operating Temp 0°C-50°C (32°F - 122°F)
Operating Humidity 0% - 99%
Bluetooth-enabled. Distance 50m/164ft (No obstacles)
1 Place in the battery (Make sure the electrode direction match is correct).
2 Install.
Mount it on the wall Stand it on the desk
1 Turn on Bluetooth in your phone and get close to the thermo-hygrometer (Location Services/GPS should be turned on for Android users).
2 Open Govee Home. tap "+" icon at the top right corner and select "H5075".
3 Follow instructions in App to complete connecting.
4 It shows Bluetooth enabled icon on LCD screen after successful connection.
5 Please check the above steps and try again if connection fails.
Message Alert: App pushes alert messages once temp/humidity is beyond preset range.
Unit Switch: Switch temp unit to °C/°F in App.
Calibration: Calibrate temp/humidity.
1 Incomplete readings showing on LCD screen.
a. Check whether the battery compacity is low or battery installation is incorrect.
b.Make sure it works within range of operating temp and humidity.
c. Avoid falling from high places.
2 Cannot manage the device with App.
Make sure your phone is within Bluetooth-enabled range.
3 Data in App cannot be refreshed.
a. Check whether Bluetooth in your phone is turned on.
b.Keep your phone close to the thermo-hygrometer.
4 No/Delayed message alerts in App.
a. Make sure Bluetooth in your phone is turned on.
b. Check whether Govee Home is allowed in your phone.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference. and (2) This device must accept any interference received. including interference that may cause undesired operation.Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: this equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet ona circuit different from that to which the receiver is connected.
4.Consult the dealer or an experienced radio/TV technician for help.
