WMFL9 User Manual

Loading ...

7 / EN

Washing Machine / User’s Manual

4.1.4 Connecting water supply

Thewatersupplypressurerequiredtoruntheproductisbetween1to10bars(0.1–1MPa).Itisnecessarytohave

10–80litersofwaterflowingfromthefullyopentapinoneminutetohaveyourmachinerunsmoothly.Attachapressure

reducing valve if water pressure is higher.

CAUTION: Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will

get damaged or the product will switch to protection mode and will not operate.

CAUTION: Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.

1 Tighten the nuts of the hose by hand. Never use a tool when

tightening the nuts.

2 When hose connection is completed, check whether there is leak

problems at the connection points by opening the taps fully. If any

leaks occur, turn off the tap and remove the nut. Retighten the nut

carefully after checking the seal. In order to prevent the water leaks

and resultant damages, keep the taps closed when you do not use

the product.

4.1.5 Connecting the drain hose to the drain

• Attachtheendofthedrainhosedirectlytowastewaterdrain,lavatoryorbathtub.

CAUTION: Your drain house will be flooded if the hose comes out of its housing during water discharge. Moreover, there

is risk of scalding due to high washing temperatures! In order to prevent such situations and make sure that the machine

performs water intake and discharge processes without any problem, fix the drain hose securely.

40 cm

100 cm

• Connectthedrainhosetoaminimumheightof40cm

and a maximum height of 100 cm.

• Incasethedrainhoseiselevatedafterlayingitonthe

floor level or close to the ground (less than 40 cm above

the ground), water discharge becomes more difficult and

the laundry may come out excessively wet. Therefore,

follow the heights described in the figure.

• Topreventthewastewatertogobackintothemachineagainandtoensureeasydrainage,donotimmerse

the end of the hose into the waste water or do not insert it into the drain for more than 15 cm. If it is too

long, cut it short.

• Theendofthehoseshouldnotbebent,itshouldnotbesteppedonandthehosemustnotbepinched

between the drain and the machine.

• Ifthelengthofthehoseistooshort,useitbyaddinganoriginalextensionhose.Lengthofthehosemay

not be longer than 3.2 m. To avoid water leak failures, the connection between the extension hose and the

drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak.

Loading ...

User Manual - Page 7