1. Home
  2. Euromaid
  3. Euromaid WMFL9 User Manual
  4. Page 6

User Manual - Page 6

For WMFL9.

Loading ...
Loading ...
Loading ...
6 / EN
Washing Machine / User’s Manual
4.1 Installation
• Preparationofthelocationandelectrical,tapwaterandwastewaterinstallationsattheplaceofinstallation
is under customer's responsibility.
• Makesurethatthewaterinletanddischargehosesaswellasthepowercablearenotfolded,pinchedor
crushed while pushing the product into its place after installation or cleaning procedures.
• Priortoinstallation,visuallycheckiftheproducthasanydefectsonit.Ifso,donothaveitinstalled.
Damaged products cause risks for your safety.
4.1.1 Appropriate installation location
• Placetheproductonahardandlevelfloor.Donotputitontoacarpetwithhighpileorothersimilar
surfaces.
• Whenthewashingmachineanddryerareplacedontopofeachother,theirtotalweight–whenloaded–
amounts to 180 kilograms. Place the product on a solid and flat floor that has sufficient load carrying
capacity!
• Donotplacetheproductonthepowercable.
• Donotinstalltheproductintheenvironmentswherethetemperaturefallsbelow0ºC.
• Leavingagapatthesidesofthemachineissuggestedtoreducevibrationandnoise
• Onagraduatedfloor,donotplacetheproductnexttotheedgeoronaplatform.
• DonotplaceheatsourcessuchasHobs,Irons,Ovens,etc.onthewashingmachineanddonotusethem
on the product.
4.1.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging reinforcement.
Remove the packaging reinforcement by pulling the ribbon. Do not make
this operation alone by yourself.
4.1.3 Remove the transportation bolts (located on the rear panel of the machine)
1 Loosen all bolts with an appropriate wrench until they turn freely.
2 Remove the transport safety bolts by turning them slightly.
3 Insert the plastic dust caps which are in the bag containing the user manual to the openings
on the rear panel.
A
CAUTION: Remove the transportation safety bolts before operating the washing machine! Otherwise, the product will be
damaged.
C
Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the
future.
Install the transport safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
Loading ...
Loading ...
Loading ...