Loading ...
Loading ...
Loading ...
20
en Troubleshooting
Cleaning the bowl and tools
Caution!
Do not wedge plastic parts in the dish-
washer, as they could be permanently
deformed during the washing process.
Bowl and double whisk are dishwasher-
proof. Dismantle double whisk for cleaning.
X Fig. D
■ Pull whisks out of the holder.
■ After drying the whisks, re-insert them,
ensuring that the gearing meshes fully.
■ Clean kneading hook with a brush under
running water. If required, use a little
washing-up liquid.
Important information
Before cleaning the bowl in the dishwasher,
take the drive shaft out of the bowl.
■ Rotate the bowl and base upwards.
■ Rotate and remove drive shaft from
the fins in an anti-clockwise direction.
■ Pull out drive shaft.
■ After drying the parts, re-insert the
drive shaft.
■ Lock drive shaft in position by rotating it
in a clockwise direction.
Cleaning the blender
X Fig. E
W Risk of injury from sharp blades!
Do not touch blade insert with bare hands.
Clean them with a brush.
Caution!
Do not use abrasive cleaning agents.
Do not clean blade insert in the dishwasher.
Do not leave blade insert in water.
It is recommended to clean the blender
immediately after use. This will prevent
residue from drying on and attacking the
plastic (e.g. by essential oils in herbs).
■ Clean blender jug (without blade insert),
lid and funnel in the dishwasher.
■ Clean blade insert with a brush under
running water. Do not leave in water!
Tip: Pour water with a little washing-up
liquid into the attached blender (approx.
half full). Switch on the blender for several
seconds (setting M). Pour out the water and
rinse out the blender with clear water.
Troubleshooting
W Risk of electric shock!
Before working on the appliance, pull out
the mains plug.
Appliance does not start
■ Check the power supply.
■ Check the mains plug.
■ Switch appliance to P and then back
to the required setting.
When using the blender:
■ Screw the blender on tight as far
as possible.
■ Attach the blender cover and screw on
as far as possible.
When using the bowl / tools:
■ Attach protective cover to the
blender drive.
Blender does not start working or stops
during use, the drive is “humming”.
The blender blade is blocked by one of
the ingredients.
■ Switch off the appliance and pull out
the mains plug.
■ Detach the blender and remove
the obstruction.
■ Re-attach the blender.
■ Switch on the appliance.
Important information
If the fault cannot be eliminated, please
contact customer service.
Loading ...
Loading ...
Loading ...