Loading ...
Loading ...
Loading ...
Black plate (230,1)
北米Model "A1220BE-A" EDITED: 2014/ 8/ 28
3-86
Instruments and controls/Wiper and washer
over the windshield or rear window.
. Grease, wax, insects or other mate-
rial on the windshield or th e wiper
blade results in jerky wiper operation
and streaking on the glass. If you
cannot remove those streaks afte r
operating the washer or if the wiper
operation is jerky, clean the outer sur-
face of the windshield or rear window
and the wiper blades using a sponge or
soft cloth with a neutral detergent or
mild-abrasive cleaner. After cleaning,
rinse the window glass and wiper
blades with clean water. The glass is
clean if no beads form on the glass
when you rinse with water.
. If you cannot eliminate the streaking
even after following this procedure,
replace the wiper blades with new
ones. For replacement instructions,
refer to “Replacement of wiper blades”
F11-33.
& Windshield wiper and washer
switches
The wiper operates only when the ignition
switch is in the “ON” or “ACC” position.
! Windshield wipers
: Mist (for a single wipe)
:Off
: Intermittent
: Low speed
:
High speed
To turn the wipers on, push the wiper
control lever down.
To turn the wipers off, return the lever to
the “
” position.
For a single wipe of the wipers, push the
lever up. The wipers operate until you
release the lever.
! Wiper intermittent time control
When the wiper switch is in the “ ”
position, turn the dial to adjust the operat-
ing interval of the wiper. The operating
interval can be adjusted in several steps
from the shortest interval to the longest.
Loading ...
Loading ...
Loading ...