Loading ...
Loading ...
Loading ...
13
RESETTING THERMAL PROTECTION
The WFP16S Food Processor is equipped with an automatic reset
switch to protect the motor from overheating.
If your food processor stops running under heavy use, turn the
power switch off and unplug the power cord. Empty the work
bowl of all its contents and discard. Allow approximately
30 minutes for the motor to cool down.
Reassemble unit, plug the power cord back into the outlet and
run rst with the bowl empty. Put food into the bowl and continue
processing.
If your food processor does not function properly following
this procedure, discontinue use and contact a Certied Waring
Customer Service Center.
USE INSTRUCTIONS FOR S-BLADE (CUTTER
BLADE)
• The sealed S-blade (cutter blade) is designed for chopping,
grinding, puréeing, blending, mixing or kneading.
• Assemble the bowl and blade as instructed in the section titled
“Assembly of Batch Bowl Parts” (page 8).
Chopping and mincing
• To chop or mince in the bowl, ll the bowl up to ¾ full.
• To chop or mince most effectively, use the pulse function. This
allows for better control over consistency. Continue pulsing until
the desired consistency has been reached.
• If chopped foods are processed continuously, the food could
be processed unevenly, i.e., food on the bottom will be nely
chopped and food on the top will be more coarse.
Chopping meat
Cut meat into 1-inch (2.5cm) pieces to ensure an even chop.
Process no more than 2.25 lbs. of meat. Press the PULSE button
3 or 4 times at a rate of 1 second on, 1 second off. If the food is
not chopped ne enough, let the processor run continuously for
a few seconds. If the machine has trouble starting, reduce the
amount of meat in the bowl and start again.
Loading ...
Loading ...
Loading ...