DH9060FS1 User Manual

Loading ...

FAULT CODES

When a continuous series of beeps sound, all the lights turn off onthe control panel and a

number appears on the display, a fault hasoccurred. The dryer will automatically enter this

mode if a fault occurs. The word FAULT will be shown in the control panel display followed

by a number. To stop the beeps, press any button then perform the following steps:

1 Turn your dryer off at the power point.

2 Wait one minute and turn it back on.

3 Check your dryer is installed correctly, refer to your separate installation guide.

4 Remove your load from the dryer and retry.

5 Perform a

TIME DRY cycle, eg TIME DRY for 30 minutes.

6 If the fault re-occurs repeat steps 1 and 2.

7 If the dryer still will not work call a Fisher & Paykel trained and supported

servicetechnician to arrange service, refer to ‘Before you call for service’.

Recordthefaultcode number displayed and the serial number of your dryer

(locatedonthe rear of the dryer, or on the insideof the door below the glass)

beforecalling. The fault code will indicateto the service technician what the

problemcould potentially be.

If a fault code is being displayed, you can still turn your dryer off by pressing

POWER .

Loading ...

User Manual - Page 37