Loading ...
Loading ...
Loading ...
©
2015 DJI. All Rights Reserved.
7
N1 Video Encoder
User Manual
3. Upgrade the Aircraft
1) Ensure the remote controller is powered off, and then power on the aircraft. The rmware
upgrade will begin automatically once the aircraft is powered on.
2) The Status LED will blink red and green alternatively to indicate that the upgrade is in
progress. It will take approximately 12 minutes to complete the rmware upgrade.
3) The Status LED will blink green if the upgrade is successful, at which point you should
restart the aircraft. Check the upgrade result by opening the .txt le that is automatically
generated in the root directory of your storage device. The text “result: Success” indicates
that the upgrade is successful.
4) If the Status LED blinks red, the upgrade is unsuccessful. Run the rmware upgrade again.
Upgrading the Intelligent Flight Battery Firmware
The Intelligent Flight Battery firmware is upgraded during the aircraft firmware upgrade. It is
recommended to keep the upgrade package files on your USB flash drive after the firmware
upgrade.
Upgrade the rmware of an extra Intelligent Flight Battery as follows:
1. Power off all the Intelligent Flight Batteries.
2. Insert the battery that needs the rmware upgrade into the battery compartment connected
to the ight controller.
3. Power on the Intelligent Flight Battery in the battery compartment. The upgrade will start
automatically.
Remove the propellers before upgrading the rmware to avoid injuries. DO NOT touch
the motors during the rmware upgrade.
DO NOT start the motors while upgrading the rmware.
DO NOT use the N1 Assistant while upgrading the rmware.
Only USB ash drives formatted with FAT32 or exFAT le systems are supported.
Ensure that there is only one rmware upgrade package on your USB ash drive.
The remote controller may become unlinked from the aircraft after the firmware
upgrade. Re-link the remote controller and aircraft if necessary.
Appendix
Status LED Blinking Patterns
Blinking Pattern Description
—— Solid Red
No video input
—— Solid Green
Video input detected
Blinking Red and Green Alternatively
Upgrading rmware
Blinking Green
Firmware upgrade successful
Blinking Red
Firmware upgrade failed
Loading ...
Loading ...