Loading ...
Loading ...
Loading ...
14
WATER SUPPLY CONNECTION
To Connect Water Supply Line To Water
Inlet Valve
1. Disconnect the refrigerator from elec-
trical power source.
2. Place the end of the water supply line
into a sink or bucket. Turn ON the water
supply and flush the supply line until
the water is clear. Turn OFF the water
supply at the shutoff valve.
3. Remove the plastic cap from the water
valve inlet and discard the cap.
4. If you use copper tubing - Slide the
brass compression nut, and then the
ferrule (sleeve) onto the water supply
line. Push the water supply line into
the water valve inlet as far as it will
go (¼"/6.4 mm). Slide the ferrule
(sleeve) into the valve inlet and finger
tighten the compression nut onto the
valve. Tighten another half turn with
a wrench; DO NOT overtighten. See
Figure 1.
If you use braided flexible stain-
less steel tubing - The nut is already
assembled on the tubing. Slide the nut
onto the valve inlet and finger tighten
the nut onto valve. Tighten another half
turn with a wrench; DO NOT overtight-
en. See Figure 2.
A Plastic Water Tubing to Water
Dispenser (foamed within the cabinet)
B Steel Clamp (Fig. 1: ¼"; Fig. 2: ½")
C Brass Compression Nut
D Ferrule (Sleeve)
E Copper Water Line
F Water Valve Bracket
G Valve Inlet
H Water Valve
I Copper Water Line from Household
Water Supply*
J Braided Flexible Stainless Steel
Water Line
*Include enough tubing in the loop to allow
moving the refrigerator out for cleaning
Figure 1
A
B
C
D
E
F
G
H
I
Figure 2
A
C
G
F
H
J
B
Loading ...
Loading ...
Loading ...