Loading ...
Loading ...
Loading ...
Turning “On”
The display on a digital style controller
will show “4”, or three bars for the digital
throw controller, the very first time the
controller is turned on after being plugged
into the warming product and wall outlet.
After the very first time, the controller
will remember your last preference and
start with that heat level when turned ON.
Memory of your setting will be reset upon
removal of power to the plug. Alternative-
ly, the analog style controller will backlight
the heat level setting on its dial after
flipping the switch. If using the analog
slide throw controller, the red LED will
illuminate after moving the slide switch
to a heat level setting. If the backlight or
display does not illuminate, or the display
reads “E” or flashes, see the FAQ section.
Note: If you have a Queen or King sized
product, you will need to connect both
controllers to heat both sides of the prod-
uct; each controller will only heat one side.
Adjusting the Temperature
To adjust a digital controller’s heat level
setting, while the controller is ON, press
one of the arrow buttons. Press the UP
arrow to increase the heat setting, and
the DOWN arrow to decrease it. Each time
you press an arrow button, the setting will
adjust by one heat level. Alternatively, the
analog style controller heat level settings
are manipulated by rotating a dial, or
sliding a switch, to the desired level. There
are multiple heat level settings, with “H”
for HIGH; the higher the number or bar,
the warmer the product.
Note: If you have a product that uses two
controllers, one for each side, each control-
ler can be adjusted to a different setting,
causing each side of the bedding to heat
differently.
Turning “OFF”
Turn the controller OFF manually by sliding
the switch to OFF or pressing the ON/OFF
button or switch. When the controller is
OFF but plugged in, the digital controller
will not display a number or bar, and the
analog controller will not illuminate the
LED or heat level setting on the dial. Turn
OFF and/or unplug the controller when not
in use.
Note: When OFF, a red or green dot may
be present on specific digital controller
models; indicating standby mode. The red
LED will not be on for the analog slide
throw controller.
Note: If you have a product that uses two
controllers, please ensure both controllers
are turned OFF and/or unplugged when
the warming product is not in use.
Note: The Auto-Off feature is not intended
to replace the manual turning OFF of the
warming product. Please turn OFF and/or
unplug the controller when not in use.
Pre-Heat ( Specific Models Only )
Turn the controller ON and press the
PRE-HEAT button. This will start pre-heating
the bedding and “p” will be displayed on
the controller. The heat setting will then
revert to the last heat setting after 1.5
hours. If you want to exit Pre-Heat and
change to another setting, press the Up
or Down button.
Instructions
10 Customer Support: 800.789.6441
Loading ...
Loading ...
Loading ...