Loading ...
Loading ...
Loading ...
||
WHEELS AND TYRES
586
WARNING
Please keep the following points in mind
when using the tyre sealing system:
•
The sealing fluid bottle contains 1) rub-
ber latex, natural and 2) ethanediol.
These substances are harmful if swal-
lowed.
•
The contents of this bottle may cause
allergic skin reactions or otherwise be
potentially harmful to the respiratory
tract, the skin, the central nervous sys-
tem, and the eyes.
Precautions:
•
Store out of the reach of children.
•
Harmful if ingested.
•
Avoid prolonged or repeated contact
with the skin. If sealing fluid has come
into contact with your clothes, remove
them.
•
Wash thoroughly after handling.
First aid:
•
Skin: Wash affected areas of skin with
soap and water. Get medical attention
if symptoms occur.
•
Eyes: Flush with plenty of water for
least 15 minutes, occasionally lifting
the upper and lower eyelids. Get medi-
cal attention if symptoms occur.
•
Inhalation: Move the exposed person
to fresh air. If irritation persists, get
medical attention.
•
Ingestion: Do NOT induce vomiting
unless directed to do so by medical
personnel. Get medical attention.
•
Disposal: Dispose of this material and
its container at a hazardous or special
waste collection point.
WARNING
Do not remove the bottle or air hose when
the puncture repair kit is being used.
1. Preparations
Set up the warning triangle and activate
the hazard warning lights if a tyre is being
sealed in a trafficked location.
If the puncture was caused by a nail or
similar, allow this to remain in the tyre. It
helps to seal the hole.
2. Detach the decal for maximum permitted
speed that is affixed on one side of the
compressor. Affix it visibly on the wind-
screen as a reminder to observe the speed
limit. You should not drive faster than
80 km/h (50 mph) after the emergency
tyre repair kit has been used.
3. Check that the switch is in position 0
(Off), and locate the electrical cable and
the air hose.
4. Unscrew the orange-coloured cap from
the compressor, and unscrew the cork
from the sealing fluid bottle.
5. Screw in the bottle to the bottom of the
bottle holder.
The bottle and the bottle holder are equip-
ped with a reverse catch to prevent seal-
ant leakage. When the bottle is screwed in
it cannot be unscrewed from the bottle
holder again. The bottle must be removed
at a workshop
10
.
WARNING
Do not unscrew the bottle, it is equipped
with a reverse catch to prevent leakage.
10
An authorised Volvo workshop is recommended.
Loading ...
Loading ...
Loading ...