Alfresco AXESB2 14 Inch BuiltIn Side Burner with 2 Brass Bur

User Manual - Page 11

For AXESB2.

PDF File Manual, 20 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
11
BEFORE TESTING:
 Make sure that all packing material is removed from the Side Burner.
 Make sure the burner tie-down straps are removed from the unit.
 Do not smoke while leak testing.
 Never leak test with an open flame.
 Make a soap solution of one part liquid detergent and one part water for leak testing purposes.
 Apply the solution to the gas fittings by using a spray bottle, or brush.
 For LP units, always check with a full cylinder.
TO TEST:
 Make sure all control valves are in the “OFF” position.
 Apply the soap solution described above to all fittings.
 Turn the gas supply on.
 Check all connections from the supply line, or LP cylinder up to and including the manifold pipe
assembly.
 Soap bubbles will appear where a leak is present.
 If a leak is present, immediately turn off gas supply, tighten any leaking fittings, turn the gas sup-
ply back on, and recheck.
 If you cannot stop a gas leak turn off the gas supply and call your dealer where you purchased
your Side Burner.
 Do not use the Side Burner until all connections have been checked and do not leak.
 Only those parts recommended by the manufacturer should be used on the Side Burner.
 Substitution can void the Side Burner’s warranty.
IMPORTANT NOTE:
ALWAYS CHECK FOR LEAKS AFTER EVERY LP TANK CHANGE.
If a leak is present, or if the connection hose shows signs of wear, these conditions must be corrected
prior to using your Side Burner.
Check all gas supply fittings for leaks before each use. It is handy to keep a spray bottle of soapy water
near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
BUTTON SYMBOLS AND LOCATIONS:
There are two buttons located on the upper left corner of the front panel of the Side burner. The upper
button is meant to be pressed momentarily during the burners ignition and the lower button is used to
turn ON and OFF the front panel accent lights
IGNITER BUTTON SWITCH
(TURN ON BURNERS)
LIGHT BUTTON SWITCH
(TURN ON ACCENT LIGHTS)
LOWER BUTTON
(ACCENT LIGHTS)
ACCENT LIGHTS
(UNDER BULLNOSE)
Loading ...
Loading ...
Loading ...