Loading ...
Loading ...
Loading ...
3. Follow the instructions on the TV screen, then press to select [Start].
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
4. Select the item you want.
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
For details on the measurement results, see “6. Checking Auto Calibration results.”
5. Save the measurement results.
Select [Save] in step 4.
Note
If an error code or warning message appears on the screen in step 3, see “List of
messages after Auto Calibration measurements.”
This setting is not available when headphones are connected.
Hint
The Auto Calibration function will be canceled if you perform the following during the
measurement process:
Press .
Press the input buttons on the remote control or turn INPUT SELECTOR on the receiver.
Press
.
Press SPEAKERS on the receiver.
Change the volume level.
Connect headphones.
[140] Adjusting Settings Speaker Settings
6. Checking Auto Calibration results
To check error codes or warning messages received in [Auto Calibration], proceed with the
following steps:
If an error code appears
Check the error and perform Auto Calibration again.
1. Select [Retry].
Loading ...
Loading ...
Loading ...