Loading ...
Loading ...
Loading ...
void the warranty.
Remove the tank(s) from the base. Rotate the mist chamber locking device to unlock
the mist chamber. Lift the mist chamber off the Base. Remove the absorption sleeve
from the heating element.
Wipe off any buildup on the heating element with a soft cloth or soft toothbrush,.
Attach a new or cleaned absorption sleeve to the heating element. Pull sleeve tightly
around the heating element and secure it with the attached Velcro fastener. See
illustrations below.
NOTE: Make sure the sleeve is tight around the heating element for best
performance.
**** Replacement Sleeve 3-Pack Item No.U-30002
To order replacement parts, please email us at Service.Optimus@gmail.com or call us at
1-888-672-5832. Always give the model number and part description when placing order.
CLEANING THE ABSORPTION SLEEVE
Hand wash the absorption sleeve using running tap water, gently rubbing the inside
and outside of the sleeve with fingers. Do not put absorption sleeve in washer or
dishwasher.
Inspect the absorption sleeve for signs of wear. Do not use if sleeve is torn, tattered,
or has holes. Replace with a new one.
NOTE: Washed absorption sleeves may build up minerals more quickly and will need
more frequent cleaning. They may experience deterioration.
CLEANING THE HUMDIFIER
It is strongly recommended to clean the humidifier at least once a week or sooner if you:
。Have hard water
。Notice a buildup of impurities
。Notice an unpleasant odor.
Always turn off and unplug the humidifier before cleaning. Be sure to wait until the
heating element has cooled sufficiently.
Wipe the tray and the housing of the humidifier with a damp soft cloth periodically. Do not
use harsh, abrasive cleaners. Never submerse the mist chamber in liquid or pour liquid in
or on it. Doing so may damage the unit and may cause injuries.
CLEANING THE TANK(S)
Put 1/2 teaspoon of chlorine bleach and 1/2 gallon of water in the tank. Let solution stand
for 20 minutes, swishing every few minutes. Empty tank(s) and rinse well with water until
the bleach smell disappears.
CLEANING THE BASE
Remove the tank(s) and mist chamber. The base may be cleaned with a damp, soft cloth
or in a dishwasher.
CAUTION: Only the base is dishwasher safe. Do not attempt to put the tank, mist
chamber or absorption sleeve in a dishwasher. Doing so may damage the
humidifier.
END OF SEASON CARE AND STORAGE
Empty all water out of the tank and base.
Clean all surfaces with a damp soft cloth.
Clean the base with a dishwasher or wiping it with a damp, soft cloth.
Remove the absorption sleeve and replace it with a new and dry sleeve.
NOTE: Before storing your humidifier for the season or for an extended period of time,
be sure the absorption sleeve is completely dry to prevent mold or mildew. Air dry
only. Do not use a dryer.
Store the unit in its original carton and in a cool dry location.
Remember to clean and inspect your humidifier before using it the next season.
TROUBLE SHOOTING:
Power light is not illuminated
Be sure the Power Control Knob is in the HIGH or LOW position.
Be sure the humidifier is plugged into the outlet.
Check outlet or circuit breaker.
Humidity light is illuminated
The Humidity light illuminates when the humidity in the vicinity reaches the
Humidistat setting. When the humidity drops below the Humidistat setting, the
humidifier will start producing moisture again and the light will disappear.
Mist output is minimal or none
Be sure Power Control Knob is in the HIGH or LOW position.
Be sure humidifier is plugged into the outlet.
Check absorption sleeve for mineral buildup.
(See REPLACING THE ABSORPTION SLEEVE and CLEANING THE
ABSORPTION SLEEVE).
Refill light is illuminated with water in tank(s)
If the tank is filled with water and the Refill light illuminates, check to see if the
tank is properly seated on the base (right tank on 3.5 gallon model) and
engages the Safety Switch located on the right side of the mist chamber (see
SET-UP).
Loading ...
Loading ...
Loading ...