Loading ...
Loading ...
Loading ...
(239,1)
北米Model "A3230BE-A" EDITED: 2021/ 5/ 19
rubbers with clean water. The glass is
clean if no beads form on the glass
when you rinse with water.
. If you cannot eliminate the streaking
even after following this procedure,
replace the blade rubbers with new
ones. For replacement instructions,
refer to “Replacement of wiper blades”
FP468.
NOTE
For models with automatic rain sensing
windshield wipers:
. When the wiper switch is turned to
the “AUTO” position while the ignition
switch is in the “ON” position, the
wipers will operate once. This indicates
that the wiper switch is in the “AUTO”
position.
. When the wiper switch is in the
“AUTO” position, the following situa-
tions may occur.
– The wipers may operate if the
rain/light sensor or the windshield
is vibrated or objects such as in-
sects, dirt, mud, etc. are covering
them. Turn off the wiper unless it is
raining or snowing.
– The wipers do not operate if the
rain/light sensor does not detect
rain or snow. If necessary, push
the wiper control lever down to the
low speed position or high speed
position.
– The wipers may not operate
properly if the rain/light sensor does
not detect the amount of raindrops
because a water-repellent coating,
dirt, or ice is on the upper half of the
windshield.
– The rain/light sensor may be
malfunctioning if the wiper intermit-
tent operation does not vary de-
pending on the amount of rainfall. If
necessary, turn the wiper switch to
any position except the “AUTO”
position. We recommend that you
contact your SUBARU dealer and
have the system inspected as soon
as possible.
– The wipers stop operation if the
ambient temperature decreases to
58F (−158C) or lower. The wipers
resume operation when the ambient
temperature increases to 148F
(−108C) or higher. If you need to
operate the wipers under 58F
(−158C), push the wiper control
lever down to the low speed posi-
tion or high speed position.
– The wipers may not operate if the
temperature around the rain/light
sensor is more than 1768F (808C)
because the system cannot detect
the amount of raindrops under
these temperatures.
. This system is also equipped with
the vehicle speed interlocking intermit-
tent wiper function. When the vehicle
stops, the wiper operation interval will
become longer compared with that
while driving.
. This system may malfunction in a
location with strong radio waves or
noise.
. If the wiper switch is in the “AUTO”
position and the wipers do not operate
when it rains, or the wiper switch is in
the “Low speed” position and the
wipers do not operate, turn the wiper
switch to the “High speed” position.
In this case, contact your SUBARU
dealer.
– CONTINUED –
Wiper and washer
237
3
Instruments and controls
Loading ...
Loading ...
Loading ...