Loading ...
Loading ...
Loading ...
14
GB
PS-LX300USB.GB.3-198-123-16(1)
8
Click [OK].
Note
To input a stereo signal from the turntable to the
computer, steps 5 through 8 are necessary.
To set the signal input level
1
Click the [Levels] tab in the [USB Audio
CODEC] property screen.
2
Move the slider to 0.
3
Adjust the slider using the cursor key.
e appropriate setting for the turntable is 2
in the [0, 0, 1, 2, 3, …] level display.
Check that the mute button is not active at
this time.
Level display
Slider
Mute button
4
Click [OK].
Note
Do not exceed the recommended setting range when
setting the input level (such as setting the le side all the
way to 0 or increasing the numerical value of the level
display). Doing so may cause the sound not to be output
or to be distorted.
For Windows 8/8.1
(Charms bar as the typical operation method)
1
Display the Charms bar on the desktop and
click the [Settings] charm.
2
Click [Control Panel], and then click
[Hardware and Sound].
3
Click [Manage audio devices] in [Sound].
4
Click the [Recording] tab, and check if [USB
AUDIO CODEC] is set to [Default Device].
5
Select [USB AUDIO CODEC], and then click
[Properties].
6
Click the [Advanced] tab.
7
Select [2 channel, ...] (for example, [2
channel, 16 bit, 44100 Hz (CD Quality)] or
[2 channel, 16 bit, 48000 Hz (DVD Quality)])
from the [Default Format] drop-down list.
8
Click the [Listen] tab, and then select the
check box next to [Listen to this device].
9
Click [OK].
Notes
To record audio aer you connected the turntable to
your computer, follow steps 1 through 4 to specify [USB
AUDIO CODEC] as the default recording device.
To send stereo signals from the turntable to your
computer, steps 5 through 7 are mandatory.
To output sounds from the built-in speakers of your
computer during recording, make the appropriate
sound output setting as described in step 8 above.
For Windows 10
([Control Panel] is in the [Category] view)
1
Right-click the [Start] menu and select
[Control Panel].
2
Select [Hardware and Sound].
3
Select [Manage audio devices] in [Sound].
4
Select the [Recording] tab and make sure
that [USB AUDIO CODEC] is set as the
default device.
5
Select [USB AUDIO CODEC], and then
select [Properties].
6
Select the [Advanced] tab.
7
Select [2 channel, ...] (for example, [2
channel, 16 bit, 44100 Hz (CD Quality)] or
[2 channel, 16 bit, 48000 Hz (DVD Quality)])
from the [Default Format] drop-down list.
8
Select [OK].
Note
To send stereo signals from the turntable to your
computer, steps 5 through 8 are mandatory.
Loading ...
Loading ...
Loading ...