Loading ...
Loading ...
Loading ...
17
3. To disassembly water valve component, use a screwdriver. Its tool edge
shall be in aligned with and inserted in the vacancy at the skirt border, which
is bulged at the top of water valve components. Rotate the screwdriver
clockwise or anticlockwise. After the rotation, use the tool bit to open the
water valve and then pull out the components with an inclination of 45°
upward.
Attention: Make sure that the water tank is empty before moving it.
The water valve components are non-detachable;
Cleaning
1. Disassemble the water tank, water tank cover, sealing ring and water valve;
2. Use cold or warm water to clean the components of the water dispenser.
3. Wipe it with dry cloth.
It is suggested to clean the water dispenser once every 3-6 months
Attention: If a cleaning solution is used for cleaning water dispenser, it is suggested to take 5-6 cups of water
after the water tank is installed back, so as to avoid the ingestion of residue cleaning solution.
Installation
1. Installation of water valve components
Align the guiding boss on the water valve components with the
guiding slot on the base, press it down with strength with an
inclination of 45°downward, until you hear a “click” sound.
2. Installation of water tank sealing ring
Make sure that the sealing ring is
properly installed on the bottom of the
water tank. The wrinkling and oblique installation and so on shall be avoided.
3. Installation of water tank components
Check that the hanging slot on the water tank components is aligned with the
suspension loop on the inner layer, and the sealing ring at the bottom of water tank
with the entrance of water value components, then insert them into the
corresponding positions with an inclination of 45°downward.
Loading ...
Loading ...
Loading ...