Loading ...
Loading ...
Loading ...
48
US
IMPORTANT SAFETY INSTRUCTIONS
WHEN INSTALLING OR USING AN ELECTRICAL APPLIANCE
BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
WARNING
Risk of electric shock! If casing is removed or handled improperly
the internal components of the unit may cause harm or become
permanently damaged. Do not expose the internal mechanisms/
components of this appliance to moisture.
1. All electrical installation and repair work should be carried out by a
qualified electrician or Dyson Field Service Technician in accordance
with current local codes or regulations.
2. Do not connect any DALI terminals to mains power. DALI wires are NOT
SELV and should never be considered touch safe. Functional level of
isolation or better is required between DALI wires and mains cabling.
3. To prevent movement and strain on the terminals, positive means of
field wiring securement must be provided during installation. The field
wiring shall be secured less than 3 inches from the cord entry and
considered with National Electrical code.
4. This appliance must be installed in accordance with NEC or your
local electrical code. If you are not familiar with these codes and
requirements, consult a qualified electrician. This appliance should
be installed with appropriate fixings for the installation environment.
Conformity and compliance is the responsibility of the installer.
5. If any part of the appliance is not working as it should, has received
a sharp blow, has been dropped, damaged, left outdoors, or been in
contact with water, do not use and contact the Dyson Helpline.
6. CAUTION: Possibly hazardous optical radiation emitted from this
product. Do not stare at the operating lamp. May be harmful to the eye.
7. Do not install or use with a damaged suspension cable. If the
suspension cable supplied is damaged it must be replaced by Dyson, its
service agent or similiarly qualified person in order to avoid a hazard.
8. This appliance is only compatible with DALI compliant dimmer products.
9. Use a dry, lint free cloth or compressed air (solvent and moisture
free) to clean the appliance. Ensure the appliance is switched off
before cleaning.
10. Ensure no pipe work (gas, water, air) or electrical cables, wires or
ductwork are located directly behind the drilling/mounting area.
11. Check that the electrical supply corresponds to that shown on the rating
plate. If the appliance is connected to any electrical supply other than
that stated on the rating plate permanent damage or improper/unsafe
operation of the appliance may result.
12. The product must be earthed.
13. The light source of this luminaire is not replaceable; when the light
source reaches its end of life the whole luminaire shall be replaced.
14. The appliance is designed for dry, internal location only.
Operating environment range 0°C (32°F) to 40°C (104°F) and 10-95%
RH non-condensing.
READ AND SAVE
THESE INSTRUCTIONS
Loading ...
Loading ...
Loading ...