Dji NAZA-M LITE User Manual

Loading ...

Fly test

Before First Flight

Notices:

 Make sure you have assembled your multi-rotor correctly.

 Make sure you have done the configuration procedure correctly.

 Any of the following mistakes will leads to a dangerous accident, double check all these items:

 Rotation direction of motor is opposite

 Propeller installation mistake

 MC installation mistake

 Wrong connection between MC and ESC

 In Atti Mode, throttle stick center position is for 0m/s along the vertical direction. You must keep the

throttle position higher than 10% from stopping the motors during the flight!

 Make sure you switch on the transmitter first, then power on multi-rotor! (Power off multi-rotor first, then

switch off the transmitter after landing!)

 Please do the fly test and gain tuning with Atti. Mode in the open air without heavy winds!

 In Atti Mode, after power on and before motors start, if or LED double blinks without move

any stick, this indicates that you have moved any sticks during system start up and check. You will have

to reboot MC before you try to fly.

Test Fly

1. Make sure your batteries are fully charged for your transmitter, MC and all the devices on your multi-

rotor;

2. Check all connections and wirings, and make sure they are in good condition;

3. Switch on the transmitter first, then power on your multi-rotor!

4. Flip the control mode switch on your transmitter, and make sure it is working properly. Check it with LED

indicator to specify the current working mode for MC. See Appendix for details about LED indicator;

5. Switch the system to Atti.

Mode. Use any safe method to do the following test: Apply the throttle to 20%

slowly and make sure all the motors are working properly, and then try to push your sticks lightly in Roll,

Pitch and Yaw to feel if your multi-rotor moves to the corresponding direction. If not, go back to

Configuration Procedure and

correct your settings.

6. Push the throttle stick slowly within 3 seconds after executing CSC until all the rotors are working, and

then take-off your multi-rotor gently

Tips:

Loading ...

Dji NAZA-M LITE Cameras