Loading ...
Loading ...
Loading ...
©2014 DJI. All Rights Reserved. 30
4 Gimbal
STEP1: Gimbal Switch
If you use gimbal, please choose On here, and select an Output Frequency (50Hz/100Hz/200Hz/400Hz).
The chosen output frequency is recommended no more than the maximum servo supported frequency.
Notices:
If you open the gimbal control in assistant software during the configuration, please note that there are outputs
from F1 and F2 ports. You should never connect these ports to ESCs which are wired with propellers and motors.
Tips:
NAZA-M LITE supports servo center 1520us.
STEP2: Servo Travel Limit
Range: -1000 to+1000
MAX/MIN are servo travel limits; adjust them to avoid mechanical binding; Place your multi-rotor on level ground,
adjust Center value of Pitch and Roll direction to make the camera mounting frame to your desired angle-to-ground.
Loading ...
Loading ...
Loading ...