Loading ...
Loading ...
Loading ...
Tire Puncture u Removing Wheels
90
Troubleshooting
13.
Remove the wheel and side collar.
u Support the brake caliper assembly so
that it doesn’t hang from the brake
hose. Do not twist the brake hose.
u Avoid getting grease, oil, or dirt on
the disc or pad surfaces.
u Do not push the brake pedal while the
brake caliper is removed.
Installation
Before installing the wheel, check that the
wheel hub and final drive gear splines are
coated with molybdenum disulfide paste.
1.
Install the side collar and position the
wheel between the swingarm and the
final drive gear case.
u Be sure the splines on the wheel hub fit
into the final drive gear case.
2.
Install the rear brake bracket and rear
brake bracket bolt.
3.
Push the rear axle shaft from the left side,
through the wheel hub and rear brake
bracket.
4.
Remove the protective tape or an
equivalent.
5.
Tighten the rear brake bracket bolt.
Recommended molybdenum disulfide
paste:
(USA only) Pro Honda Moly 60 paste or
equivalent
NOTICE
When installing the brake caliper into position, carefully
fit the brake disc between the pads to avoid scratching
them.
Torque: 51 lbf·ft (69 N·m, 7.0 kgf·m).
Loading ...
Loading ...
Loading ...