Loading ...
Loading ...
Loading ...
EN – 52
See Figure 129.
15. Wrap seal protector around each auger shaft end so
they cover the shear bolt holes.
NOTICE: Unprotected seals can be damaged when
installed over rough edges in shaft, such as holes.
16. Install gearcase seals over seal protectors and press
into gearcase until each seal is flush with gearcase
exterior.
17. Remove seal protectors.
18. Turn auger shaft by hand to make sure shaft rotates
easily.
19. Reinstall bushing retainer into flange bushing groove.
See Figure 130.
See Figure 131.
20. Reinstall gearcase gasket.
21. Secure cover to gearcase with four external tooth
locking washer bolts.
See Figure 132.
22. Press a new front cover into gearcase.
23. Add gearcase oil. Oil level MUST be 6.1 – 6.7 cm
(2.4 – 2.6”) from the flat surface of the gearcase cover.
IMPORTANT: Ariens recommends using only Ariens L3
synthetic severe duty gear lube. Using other lubricants will
not automatically void unit warranty, but the warranty will
not cover damage caused by using unauthorized
lubricants. Refer to the Operator’s Manual for your unit for
the service part numbers.
24. Reinstall seal washer (rubber side down) and oil fill
plug. Torque to 9 N•m (80 lb-in). DO NOT over-torque.
Figure 129
Figure 130
Figure 131
Loading ...
Loading ...
Loading ...