Loading ...
Loading ...
Loading ...
EN – 45
Install Actuation Gear
Models 921045, 921046, 921047, 921048, 921049,
921323, 921324, 921325
1. Install one flat steel washer onto actuation gear and
insert gear through actuation gear bracket.
2. Install push nut onto actuation gear so it is tight
against actuation gear bracket.
3. Reinstall actuation gear bracket to pedestal plate and
secure with two tapping screws.
4. Reinstall chute rotation rod into chute gear and secure
with spring clip.
5. Reinstall chute gear cover and secure with tapping
screw.
6. Adjust discharge chute. Refer to Operator’s Manual
for adjustment procedure.
7. Reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
Install Actuation Gear
Model 921326
1. Install two flat steel washers onto actuation gear.
2. Install actuation gear into chute gear bracket.
3. Reinstall chute rotation gear. See Install Chute
Rotation Gear on page 43.
SCRAPER BLADE REPLACEMENT
Remove Scraper Blade
IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove hardware securing scraper blade ends to
auger housing. See Figure 108.
See Figure 109.
4. Slowly tip unit back so it rests on handlebars.
5. Remove remaining hardware securing scraper blade
to auger housing and remove scraper blade.
WARNING: AVOID INJURY. Before tipping unit
onto handlebars, drain fuel from tank and fuel
system. See Draining Fuel System on page 7.
Make sure unit is secure and will not tip.
Figure 108
Figure 109
Loading ...
Loading ...
Loading ...