Loading ...
Loading ...
Loading ...
Part # MPSM07 (03/24/08) Page 17
OPERATING INSTRUCTIONS, (Standard Models)
In O Mode
When the oven is o, there are no lights or indicators. The
oven interior light will operate.
Start Up
Press the Cook/O/Cool Down rocker switch to the COOK
position. The green lamp will light indicating the oven is
powered in cook mode.
The oven will begin to heat to the temperature set on the
thermostat dial. The amber lamp will light indicating the heat
is active. As the heat cycles on and o to maintain the set
temperature this light will go on and o accordingly.
Garland “safe door” feature will be operational. The door must
be closed tightly for the oven to operate in cook mode.
Fan Speed
The fan speed can be either high, (1725 RPM), or low, (1140
RPM). The fan speed is controlled by the left rocker switch
positions marked HI and LO.
Interior Light
The oven interior light is activated by pressing the light
switch. This is a momentary switch. The light will stay lit as
long as this button is held in the on position. The light will
operate in any mode, whenever there is electrical power
connected to the oven.
Cool Down
Pressing the Cook/O/CoolDown rocker switch to the
COOLDOWN position activates the fan and motor to cool the
oven cavity. The door must be open slightly for the fan and
motor to start. Heat is not active in this mode.
Optimal cool down will be achieved with the door open
slightly .If the door is opened too wide the motor and fan
will shut o. This is a safety feature. When the door is partially
closed again the motor and fan will operate.
Cool down will continue to operate until the control is
changed. Pressing the rocker switch to the OFF position
cancels Cool Down and turns the oven o.
Temperature
The temperature range is from 150°F, (66°C), to 500°F, (250°C).
Temperature is controlled by aligning the indicator to the
desired temperature.
Timer
The timer is set by rotating the dial clockwise, aligning the
indicator to the desired time cycle. The timer will count down
from 3 minutes to 1 hour. At the end of the timing cycle, a
buzzer will sound. The buzzer is turned o by rotating the dial
counterclockwise to the OFF position.
Moisture Control
When the Moisture Switch is set to AUTO, moisture will be
injected at the rate set by the moisture control. Rotate the
dial counterclockwise to decrease moisture. Rotate the dial
clockwise to increase moisture.
Moisture Switch
This is a three-position switch to control how the moisture
is injected into the oven; manually, not at all (o ), or
automatically. The OFF and AUTO settings are xed. The MAN,
(manual), position is momentary. This momentary actuator
injects water when pressed. It is strongly recommended that
moisture only be injected manually by holding the button for
one second at a time.
NOTE: Water can only be injected after the oven has
preheated to at least 225°F (107°C)
Loading ...
Loading ...
Loading ...