Loading ...
Loading ...
Loading ...
3 Operating the appliance
Power level After-running time in minutes
20
15
10
(flashing) 5
Leave the appliance running for a few minutes after cooking so as to extract all the
cooking smells.
3.6 Saturation indicators
Metal grease filters
The LED for the button flashes after 20 operating hours. The saturation level has been
reached and the metal grease filters must be cleaned.
Resetting the saturation indicator after cleaning
▸ While the corresponding LED for the or button flashes:
▸ Hold the button depressed for 5 seconds.
– The LED for the or button stops flashing.
3.7 OptiLink
With this function, the user no longer needs to control the range hood manually. OptiLink
monitors the power levels set for the cooking zones and automatically sets the optimum
power level for the range hood. The following settings are available for selection:
- OFF OptiLink is turned off
Silent mode Low noise level operation
Standard mode Normal mode
Intensive mode High power for extracting cooking fumes and
smells
Establishing a connection from the range hood to the hob
The range hood can only be connected to hobs that have the OptiLink function.
▸ For activating the «connecting mode» on the hob: see the operating instructions for
the hob.
▸ For activating the «connecting mode» on the range hood:
▸ Switch the appliance and the illumination off.
▸ With the appliance switched off, hold the button depressed for 5seconds.
– The LED for the button flashes while the «connecting mode» is active.
– If a connection could be established to the hob, illuminates briefly and then the
range hood is ready for both OptiLink and manual operation.
– If no connection could be established, the LED for the button stops flashing. In
this case, another attempt at establishing a connection can be made.
▸ If a connection could be established, this must be confirmed on the hob. See the op-
erating instructions for the hob for this.
11
Loading ...
Loading ...
Loading ...