Loading ...
Loading ...
Loading ...
WARNING:
Smother flames with a close-fitting lid,cookie sheet, or other metal tray, then turn
off the gas burner or the electric element. Be careful to prevent burns. If the flames
do not go out immediately, evacuate and call the fire department.
Never pick up a flaming pan - you may be burned.
Do not use water, including wet dishcloths or towels - a violent steam explosion will result.
Use an extinguisher only if:
You know you have a class ABC extinguisher, and you already know how to operate it.
The fire is small and contained in the area where it started.
The fire department is being called.
You can fight the fire with your back to an exit.
To reduce the risk of injury to persons, in the event of a cooker top grease
fire, observe the following:
CAUTION:
Always leave safety grills and filters in place.
5 ENGLISH
ELECTRICAL REQUIREMENTS
IMPORTANT
It is the customer's responsibility:
to contact a qualified electrical installer.
to assure that the electrical installation is
adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 - latest
edition*,or CSA Standards C22.1-94,
Canadian Electrical Code, Part 1 and C22.2
No.0-M91-latest edition**
and all local codes and ordinances.
If codes permit and a separate ground wire is
used, it is recommended that a qualified
electrician determines that the ground path is
adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not
sure range hood is properly grounded.
Do not have a fuse in the neutral or ground
circuit.
IMPORTANT
The range hood must be connected with
copper wire only.
The range hood should be connected directly
to the fused disconnect (or circuit breaker) box
through metal electrical conduit.
Wire sizes must conform to the requirements
of the National Electrical Code ANSI/NFPA
70 - latest edition”, or CSA Standards C22.1-
94, Canadian Electrical Code Part 1 and
C22.2 No.0-M91 - latest edition** and all local
codes and ordinances.
A U.L.- or C.S.A.-listed conduit connector
must be provided at each end of the power
supply conduit (at the range hood and at the
junction box).
Copies of the standards listed may be obtained
from:
* National Fire Protection Association Battery
march Park Quincy, Massachusetts 02269
* * CSA International 8501 East Pleasant Valley
Road Cleveland, Ohio 44131-5575
Power requirement:
120V-, 60Hz, 15 or 20A branch circuit.
Save installation instructions for electrical
inspector's use.
Observe all governing codes and
ordinances.
To Reduce The Risk Of Fire And Electric Shock,
Install This Rangehood Only With Integral Blowers
Manufactured by Chinabest Home Appliance Co.,
Ltd, Model CTH03-128D.
Loading ...
Loading ...
Loading ...