Loading ...
Loading ...
Loading ...
47
Troubleshooting en-us
Rust spots on the silverware. Silverware not adequately rust-
resistant. Knife blades are frequently
more severely affected.
Use corrosion-resistant silverware.
Silverware will also rust if rusting
parts are rinsed at the same time (pan
handles, damaged utensil baskets,
etc.).
Do not wash rusting parts.
Salt content in the rinsing water too
high, as salt dispenser lock not
fastened firmly or salt was spilled
while being refilled.
Fasten salt dispenser lock firmly or remove
spilled salt.
Dishwasher cannot be switched
on or operated.
Malfunction. Disconnect dishwasher from the power
supply; pull out the power supply plug or
switch off the fuse. Wait at least 5 seconds,
then connect the dishwasher to the power
supply.
Dishwasher does not start. Power supply fuse may have been
blown or circuit breaker tripped.
Replace blown fuse or reset tripped circuit
breaker.
Door may not be properly latched. Press the main power switch to turn unit on.
Unit may not be turned on. Shut door completely.
Delay start may be engaged. To reset, refer to “Delay start” section in this
manual.
Child lock is activated. Deactivate the child lock. Refer to “Child
Lock” section in this manual if applicable.
The door may have been closed
without first selecting a cycle.
Select a cycle and close the door.
Power cord not inserted. Ensure that the power cord is plugged all
the way into the back of the dishwasher and
into the socket. Check that the socket
functions.
The water supply may not be
connected.
Check and turn on water supply.
The dishwasher door has not been
shut properly.
Close the door.
The door has been open for more
than 4 seconds after pressing the
START button.
Press the START button again and close the
dishwasher door within 4 seconds (see
“Protection against unintentional
operation”).
Wash cycle starts automatically. You did not wait until wash cycle
ended.
Perform reset.
(see “Canceling the wash cycle“).
Fault Cause Remedial action
Loading ...
Loading ...
Loading ...