Loading ...
Loading ...
Loading ...
17
Water softening system / special salt en-us
Adjusting the water softening system
The amount of salt dispensed can be set from 0 to 62°E.
Salt is not required at the set value 0-8.
Set the softening system as follows:
1. Ask your local water utility company for the water
hardness value of the tap water.
2. Required setting can be found in the water hardness
table.
3. Open the door.
4. Switch on ON/OFF switch (.
5. Press Info button ( 8 for 3 seconds until the
following text is indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with t 3 sec.
6. Keep pressing button > ` until the water hardness
is indicated on the display window at the top @.
7. Make the selection with setting buttons + - X.
8. Press and hold the Info button (8 for 3 seconds.
The chosen setting has now been stored.
Using special salt
As soon as the low salt indicator P lights up on the
digital display, salt should be topped off. Refilling the
salt dispenser should be done before switching on the
appliance. This ensures that extra salt water is washed
out and will not corrode the rinsing tank.
NOTICE: Detergent will destroy the water softening
system! Never pour detergent into the salt dispenser.
Top off the salt as follows:
1. Undo the screw plug on the dispenser 1b.
2. Fill the dispenser with water (required only when
switching on the appliance for the first time).
3. Add salt as illustrated (do not use table salt or tablets).
The water is displaced and runs out.
For more information about buying dishwasher salt,
please contact Customer Service 1-800-944-2904.
Using detergents with salt component
Det er gent with a sal t compon en t
If combined detergents with a salt component
are used, special salt can usually be omitted up
to a water hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l). If the water hardness is over 21° dH, salt
must be used.
Switching off low salt indicator / water
softening system
Switching of f wat er sof t eni ng sy st em
If the use of combined detergents with a salt
component impairs the low salt indicator P on the
control panel or the text on the display window at the
top @ (enough salt for x rinse cycles), the displays
can be switched off.
Proceed as described under “Setting water softening
system” and set the value to 0-8. The water softening
system and salt refill indicator are now switched off.
Loading ...
Loading ...
Loading ...