User Manual Govee ‎B5054002 Water Detectors 5 Pack, 100dB Adjustable Audio Alarm, Sensitive Leak and Drip Alert

• Owner's manual - (English)

Table of contents

• At a glance
• Specification
• Installing your Device
• Using your device
• Troubleshooting and Warning

At a glance

Sensor contact Detecting dripping

Sensor probe Detecting water seepage

Pairing /Mute button Pairing, testing, pausing alerts

Install Batteries AAA battery 2

Specification

Installing your Device

1.Pull out the battery insulation sheet;

2.Placement.

Using your device

1 Detecting dripping

When detecting dripping or seeping water on the ground, the product will emit a 100dB alarm.

2 Removing the alarm

Please dry the sensor first and then the alarm would be removed.

3 Low battery alarm

When the power compacity is less than 5%

Please replace the battery in time.

When the power runs out

4 If you have purchased extra the Wi-Fi Smart Water Leak Detector, you could add these detectors to the original gateway

Instructions are as follows:
Step1. The gateway will enter into the pairing mode;

Step2. The sensor sends the pairing signal;

Step3. The gateway received the signal:

Step4. Connection Succeeded.

Attention

a. If you have not paired the gateway and sensor successfully within 30s, the gateway indicator will turn blue automatically and flash quickly, and then exit the pairing mode;

b. If the connection fails, please carefully check the above steps and repeat the attempts.

5 When the sensor is paired successfully to the gateway, the app could push alerts remotely and could also provide more intelligent features

Troubleshooting and Warning

Troubleshooting

The product does not work?

a. Pull out the insulation sheet before use.

b. Check the battery capacity.

c. Make sure that the product is installed correctly.

Warning

a. Do not place the device in the water.

b. Please dry it in time after encountering water.