Loading ...
Loading ...
Loading ...
UC2024 and UC2724 User Manual
November 2019
Page 7
The location of the equipment should be selected
with care. Consideration should be given to allow
adequate space for air cooled models to breathe.
The ice machine is not designed for outdoor
use. It must be installed indoors, in a controlled
environment. The air and water temperatures must
not exceed rated limits.
Scotsman assumes no liability or responsibility of
any kind from products manufactured by Scotsman
that have been altered in any way, including the use
of any part and/or other components not specically
approved by Scotsman.
Scotsman reserves the right to make design changes
and/or improvements at any time.
Specications and design are subject to change
without notice.
Airow on air cooled models:
• Intake from the right grill
• Exhaust from the left grill
Do not install where this air ow is blocked.
The power outlet must be located within the length
of the supplied power cord. If legs will be used, allow
space for the total cabinet height.
Air cooled models in a small room will require
ventilation to exhaust heat from the condenser. The
condenser fan and motor will generate some noise
while the machine is running. Noise sensitive areas
should consider water cooled equipment or locate
the machine where the noise from ice making will not
objectionable.
Unpack
1. Separate the carton from the shipping pallet
2. Inspect for any hidden shipping damage. If
any is found, retain carton and notify carrier for
potential claim. Shipping damage is not covered
by warranty.
Tip Over hazard.
To prevent injury or damage to
the machine please use caution
when lifting the unit.
3. Remove bolts holding machine to pallet.
4. Install the legs. The legs are to be screwed into
the same holes the shipping bolts were removed.
5. Remove the protective plastic covering the panels.
The longer it is left on the panel, the more dicult
it will be to remove it.
Spacing:
No additional spacing is required at the top or sides.
However, suggested minimum side clearance for the
installation is 1/8’’ or 3.2 mm and suggested minimum
top clearance is 1/4” or 6.4 mm.
The machine may be installed with 0 clearance at the
back. Do not block louvers at the front of the cabinet.
Pre Installation:
Water supplied to the ice machine should be ltered.
Install a lter system that lters out suspended solids.
It may be necessary to add a coarse pre-lter ahead
of the ne lter.
Inspect the place where the ice machine is to be
installed. Check for:
• Space for the cabinet
• Water Supply
• Drain Availability
• Electrical Power Supply
Placement
CAUTION
Loading ...
Loading ...
Loading ...