Scotsman Uc2724 Undercounter Ice Machine

User Manual - Page 12

For UC2724. Also, The document are for others Scotsman models: UC2024

PDF File Manual, 19 pages, Read Online | Download pdf file

UC2724 photo
Loading ...
Loading ...
Loading ...
UC2024 and UC2724 User Manual
November 2019
Page 12
For The Technician: Indicator Light Reference
There are four indicator lights visible when the
electrical component drawer is pulled out.
Timer Cut In
This light is switched ON when the freeze cycle has progressed signicantly enough for the
evaporator thermostat to have reached its freeze preset temperature. At this point there are only
a few minutes left in the freeze cycle. It is also switched ON when the harvest cycle has been on
and the evaporator thermostat has reached its set defrost temperature.
Curtain Switch
Normally OFF. This light is switched on and o󰀨 by the position of the ice sensing plate.
Freeze Cycle.
Normally ON during a freeze cycle. OFF during harvest or ice release.
Anti Slush
Normally OFF. This light is switched ON when the pump is stopped during a freeze cycle.
A typical cycle begins when there is no ice on the ice sensing plate (Curtain Switch light OFF). The compressor
and water pump will switch ON and when the discharge pressure increases to the cut in point of the fan
pressure switch the fan motor will begin to rotate the fan. The hot gas and inlet water solenoids are o󰀨.
This continues until the evaporator temperature sensor reaches a preset point, which causes the pump to stop
for a few seconds (the Anti Slush light will switch ON). After the Anti Slush light goes out and the water pump
is switched back on, the freeze cycle continues until the evaporator temperature sensor reaches the timer start
point, (Timer Cut In light is switched on).
When the timer has reached the end of its preset freeze time, Harvest begins (the Freeze Cycle light is
switched o󰀨). The water pump stops, the hot gas valve and inlet water solenoid valve open and the discharge
pressure falls, so the fan motor stops. Harvest continues until the released ice causes the ice sensing plate to
move and the Curtain Switch light will either: a) blink On and O󰀨, if the ice bin is not full, or b) switch On when
the bin is full and ice is on the ice sensing plate.
If the bin is full the machine will shut o󰀨 and be in a stand by mode. If not full, the cycle will repeat.
Loading ...
Loading ...
Loading ...