Loading ...
-2-
Battery Protection
Maintenance
Battery Installation & Charging
Controller
* Never try to repair circuitry. No serviceable circuitry are located inside the drone or transmitter.
* To avoid a choking hazard, keep all deteachable parts out of reach of small children.
* The drone is very powerful when taking off. Make sure to move the throttle forward gradually
to avoid it rising too quickly.
* After initial flight, turn off the drone first before you turn off the controller.
* Do not put the battery in high temperature or near extreme heat source.
* To avoid injury or damage, the drone should be flown 2 meters / 7 feet from people
or other obstacles.
* Children should only fly the drone under adult supervision. Always keep the drone
in clear sight while operating.
* Always make sure to turn off the power of the controller and drone when not in use.
The drone is equipped with low-voltage protection. When the batteries for the drone are low, the
internal programmed control system will automatically stop electrical supply to the drone’s rotors.
When the batteries are low, bring the drone to an area where you can begin charging the battery.
Allow the battery to charge fully before flying the device again.
* Clean the drone with a clean, dry soft cloth only.
* To avoid irreparable damage, keep the drone dry and away from water. Do not fly in
rainy conditions.
* Check the drone and accessories for any damage. If damage is found, do not use the
drone until it is repaired.
Battery installation should be done under adult supervision only!
Do not mix old and new batteries.
Do not mix different types of batteries.
To install the batteries: Open the cover of battery case, insert 4 X 1.5V AAA batteries,
according to indicated polarity (batteries not included).
Battery cover
4 X 1.5V AAA
batteries
Loading ...
Loading ...
Loading ...