Loading ...
Loading ...
Loading ...
85
Signal Strength
If an Arlo Pro 2 camera’s signal to the base station is weak, recording delays might
occur when motion is detected.
To test whether the camera signal is strong enough, check the camera LED on the
base station; if it’s blinking amber, the base station detects a low data rate, which
means that a camera is too far from the base station.
Follow these tips to increase signal strength:
• Position your base station so that it is central to all of your cameras.
• Position your camera a maximum of 300 feet (90 meters) from the base station.
The maximum line-of-sight range of 300 feet is reduced by each wall, ceiling, or
other large obstruction between the camera and base station. The following
materials reduce signal strength the most:
• Unusually thick walls and ceilings
• Brick
• Concrete
• Stone
• Ceramic
• Glass, especially mirrors
• Metal
• Large quantities of water, such as the water in a fish tank or water heater
• Mount your cameras away from devices such as cordless phone bases, baby
monitors, and microwave ovens.
• Do not place your Arlo system near multiple WiFi routers. Other WiFi-enabled
devices can interfere with Arlo’s wireless signal.
Reset the Arlo Base Station to Factory Settings
Performing a factory reset returns your base station values to the default
settings. It also removes the serial number from your Arlo account.
¾ To perform a factory reset on your base station:
1. Use a straightened paper clip to press and hold the Reset button on the back
of the base station for about 10 seconds.
When the base station reset completes, the LEDs on the front of the base
station blink amber. When the LEDs stop blinking amber, your base station
reboots. The base station is removed from your Arlo account.
Loading ...
Loading ...
Loading ...