Loading ...
Loading ...
Loading ...
ENGLISH
11
36
37
36
37
35
38
36
37
Fig.H
Attaching a Dust Extraction System to the
Fixed Base (Fig. I)
(Included with some models)
To connect the router to a dust extraction system for dust
collection, follow these steps:
1. Remove the motor unit from the base. Refer to
Removing the Motor from theFixed Base.
2. Attach dust extraction system attachment accessory
28
to the base as shown. Tighten thumb screws
29
securely byhand.
3. Attach hose adapter to dust extraction system
attachmentaccessory.
4. When using dust extraction system attachment, be
aware of the placement of the dust extraction system.
Be sure that the dust extraction system is stable and that
its hose will not interfere with thework.
Fig.I
28
29
Attaching a Dust Extraction System to the
Plunge Base (Fig. J)
(Included with some models)
1. Remove the motor unit from the base. Refer to
Removing the Motor from the PlungeBase.
2. Slide tab
30
(inset) on dust extraction system
attachment
34
into slot in plunge base and snap
tab
31
(inset) into hole in plungebase.
3. Secure to base with supplied plastic washer
32
and
thumb screw
33
. Tighten thumb screw securely
byhand.
4. Attach hose adapter to dust extraction
systemattachment.
When using dust extraction system attachment, be aware
of the placement of the dust extraction system. Be sure
the dust extraction system is stable and its hose will not
interfere with thework.
Fig.J
30
34
31
32
33
Set-Up: Fixed Base (Fig. A, K, L)
Inserting the Motor into the Fixed Base
1. Open the locking lever
12
on thebase.
2. If the depth adjustment ring
5
is not on the motor
6
,
thread the depth adjustment ring onto the motor until
the ring is about halfway between the top and bottom
of the motor as shown. Insert the motor into the base
by aligning the groove on the motor
6
with the guide
pins
17
on the base. Slide the motor down until the
depth adjustment ring snaps intoplace.
NOTE: Guide pin grooves
9
are located on either side
of the motor so it can be positioned in twoorientations.
3. Adjust the depth of cut by turning the depth
adjustment ring. Refer to Adjusting the Depth ofCut.
4. Close the locking lever
12
when the desired depth
isachieved.
Fig. K
21
12
21
Loading ...
Loading ...
Loading ...