Loading ...
Loading ...
Loading ...
Routine maintenance
Omnidirectional wheel
1. Turn the robot over.
2. Use a small screwdriver to separate the axle and the tire.
3. Rinse the axle and tire with water to remove any hair and dirt.
4. Dry and rebuild the wheel, then press it back in place.
System Reset
If the robot does not respond when you press a button or the
robot cannot be shut down, press the Reset button. The robot
will then restart.
Note:
After a system reset, cleaning schedules, WiFi and other settings will be
restored to factory settings.
Note:
The omnidirectional wheel bracket cannot be removed.
Machine sensors
Use a soft dry cloth to wipe and clean all sensors, including:
1. Four cliff sensors at the bottom of the robot.
2. The wall sensor on the right of the robot.
3. The charging contact on the bottom of the robot.
Wheel
Axle
Bracket
Cliff Sensor
Omnidirectional
Wheel
Charging Contact
Side Brush
Wall sensor
Restore factory settings
If the robot is not functioning after a system reset, turn it on,
then press the Reset button. Then press and hold the
button until you hear the “Start restoring initial version"
voice alert. The robot will then be restored to factory settings.
Firmware update
Update the robot using the app. Place the robot on the
charging dock and ensure that the battery level is higher
than 20% before updating. The power indicator will flash
white quickly during a firmware update.
25
*
Frequent cleaning is recommended
*
Monthly cleaning recommended
Loading ...
Loading ...
Loading ...