Loading ...
Loading ...
Loading ...
1.5m
1.5m
Instructions for use
Charging
Auto: After cleaning, the robot will automatically return to
the charging dock to recharge.
Manual: In Pause mode, press the button to send the
robot back to the charging dock.
The power indicator will flash slowly as the robot charges.
Note:
If the cleaning cycle was started away from the charging dock and the
robot could not return to the dock after cleaning, it will instead return to
its starting point. Place the robot directly on the dock to recharge it.
Spot Cleaning
In the Standby or Pause mode, press and hold the
button to start spot cleaning. This mode is used to clean a
1.5m x 1.5m square area centered on the robot. After
cleanup, the robot will return to the center of the square.
Error
If an error occurs while the robot is cleaning, the power
indicator will flash red quickly, and you will hear a voice alert.
See "Troubleshooting" for resolution options.
Note:
• The robot will go to sleep automatically if left in an Error state for over 10-minutes.
• Placing the robot on the charging dock in an error state will stop the current cleanup.
Reset WiFi
If your phone cannot connect to the robot because you have
changed your router configuration, forgotten your password,
or any other reason, open the top cover to see the WiFi
indicator light then press and hold the button and the
button until you hear the “Resetting WiFi” voice alert. When
the WiFi indicator light flashes slowly, reset is complete.
Note:
If the robot is left connecting to the network for over an hour, its WiFi will
be disabled. Reset WiFi before attempting reconnection.
18
Note:
Pressing any button will cancel the current spot cleaning cycle.
Loading ...
Loading ...
Loading ...