Loading ...
Loading ...
Loading ...
14
Chopper Accessory (C)
The choppers (9/10) are perfectly suited
for chopping meat, hard cheese, onions,
herbs, garlic, vegetables, bread,
crackers and nuts.
Use the «hc» chopper (9) for fine results.
Use the «ca» (10) for larger quantities
and for hard foods.
Refer to the Processing Guide C for
maximum quantities, recommended
times and speeds.
Maximum operation time for the «hc»
chopper: 2 minutes for large amounts of
wet ingredients, 30 seconds for dry or
hard ingredients or amounts < 100 g.
Immediately stop processing when motor
speed decreases and/or strong
vibrations occur.
Before Use
Pre-cut foods into small pieces for
easier chopping.
Remove any bones, tendons and
gristle from meat to help prevent
damage to the blades.
Make sure the anti-slip rubber ring
(9d/10d) is attached to the bottom of
the chopper bowl.
Assembly and Operation
Carefully remove the plastic cover from
the blade.
The blades (9b/10b) are very sharp!
Always hold them by the upper plastic
part and handle them carefully.
Place the blade on the center pin of
the chopper bowl (9c/10c). Press it
down and give it a turn so that it locks
into place.
Fill the chopper with food and put on
the lid (9a/10a).
Align the chopper with the motor part
(3) and click together.
To operate the chopper, switch on the
appliance. During processing, hold the
motor part with one hand and the
chopper bowl with the other.
Always chop harder foods (e.g.
parmesan cheese) at full speed.
When chopping is complete, unplug
and press the release buttons (5) to
detach the motor part.
Lift the lid up. Carefully take out the
blade before pouring out the contents
of the bowl. To remove the blade,
slightly turn it then pull it off.
Caution
Do not use the chopper accessorie) to
process extremely hard foods, such as
unshelled nuts, coffee beans, grains,
or hard spices e.g. nutmeg.
Processing these foods could damage
the blades.
Never place the chopper bowl in the
microwave oven.
«hc» Recipe example: Honey-Prunes (as
a pancake stuffing or spread):
40 g prunes
40 g creamy honey
10 ml water (vanilla-flavoured)
Fill the «hc» chopper bowl with prunes
and creamy honey.
Chop 4 seconds at maximum speed
Add 10 ml water (vanilla-flavoured).
Resume chopping for another
1,5 seconds.
Care and Cleaning (D)
Always clean the hand blender
thoroughly after use.
Unplug hand blender before cleaning.
Do not immerse the motor part (3) or
gearbox (8a, 10a) in water or any other
liquid. Clean with a damp cloth only.
All other parts can be cleaned in a
dishwasher. Do not use abrasive
cleaners that could scratch the
surface.
You may remove the anti-slip rubber
ring from the bottom of the bowl for an
extra thorough clean.
5722113354_MQ 500-525-527-535 INT.indd 145722113354_MQ 500-525-527-535 INT.indd 14 18.05.18 08:5618.05.18 08:56
Loading ...
Loading ...
Loading ...