Loading ...
Loading ...
Loading ...
1.
Install the side collar and position the
wheel between the swingarm and the final
drive gear case.
u Be sure the splines on the wheel hub
fit into the final drive gear case.
2.
Install the rear brake bracket and rear
brake bracket bolt.
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
3.
Push the rear axle shaft from the left side,
through the wheel hub and rear brake
bracket.
4.
Remove the protective tape or an
equivalent.
5.
Install the rear axle nut and washer.
Tighten the rear axle nut.
Torque: 94 lbf·ft (127 N·m, 13.0 kgf·m)
6.
Tighten the rear brake bracket bolt.
Torque: 51 lbf·ft (69 N·m, 7.0 kgf·m)
7.
Tighten the axle holding bolt.
Torque: 20 lbf·ft (27 N·m, 2.8 kgf·m)
8.
After installing the wheel, apply the brake
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
Before installing the muffler, replace the
exhaust pipe gasket with a new gasket.
20161223101558_31MFR6700_enu_BOOK Page 105 Friday, December 23 2016 10:19:27 JST
Tire Puncture u Removing Wheels
Troubleshooting
102
Loading ...
Loading ...
Loading ...