Loading ...
Loading ...
Loading ...
35
1. Unfold the paper template and place it flat on
the floor with the back and side edges positioned
exactly where the back and sides of the range will
be located when installed. (Use the diagram to
locate the brackets if the template is not available.)
2. Mark on the floor the location of the 4 mounting
holes shown on the template. For easier installation,
3/16″ diameter pilot holes, 1/2″ deep can be drilled
into the floor.
3. Remove the template and place the brackets
on the floor with turned up flanges to the front.
Line up the holes in the brackets with marks on
the floor and attach with the 4 screws provided.
Brackets must be secured to a solid floor. If
attaching to masonry floor, first drill 3/16″
diameter pilot holes using a concrete bit.
4. Level the range if necessary, by adjusting
the 4 leg levelers with a wrench. (A minimum
clearance of 1/8″ is required between the
bottom of the range and the rear leveling feet.)
5. Slide the range into place making sure
the rear legs are trapped by the ends of the
brackets. The range may need to be shifted
slightly to one side as it is being pushed back
to allow the rear legs to align with the brackets.
Remove the storage drawer to inspect brackets
or grasp the top rear edge of the range and
carefully attempt to tilt it forward to make sure
the range is properly anchored.
IMPORTANT SAFETY WARNING
This range must be properly secured to the
floor by using the included anti-tip brackets and
screws. Failure to install the brackets could allow
the range to accidentally tip over if excessive
weight is placed on an open door or if a child
climbs upon it. Serious injury might result from
spilled hot liquids or from the range itself. Refer
to the instructions below for proper installation.
NOTE: If the range is ever moved to a different
location, the anti-tip brackets must also be moved
and installed with the range.
ANTI-TIP BRACKET INSTALLATION
INSTRUCTIONS
Tools Required:
• 5/16″ Nutdriver or flat head screwdriver
• Adjustable wrench
• 3/8″ Electric drill & 3/16″ diameter bit
• 3/16″ diameter masonry drill (if installing
in concrete)
Brackets attach to the floor at the back of the
range to hold both rear leg levelers. When
fastening to the floor, be sure that screws do
not penetrate electrical wiring or plumbing.
The screws provided will work in either wood
or concrete.
Slide back
3/4″
1/2″
3/4″
Back edge of range or rear wall
Range side
panel location
Loading ...
Loading ...
Loading ...